A Plus Topper

Improve your Grades

MD3411 - Analog and Digital Electronics Laboratory Syllabus Regulation 2021 Anna University

by

Analog and Digital Electronics Laboratory syllabus regulation 2021 of Anna University B.E Medical Electronics. In this article, we would like to provide the semester IV of the B.E Medical Electronics Engineering Syllabus.

We would like to discuss the detailed syllabus of the Subject code MD3411 – Analog and Digital Electronics Laboratory. You can easily note down and take notes according to the syllabus. We add a unit-wise syllabus to this page. Along with that, we included the required textbooks and references from the expert faculty. You can also prepare for exams with a clear picture of the syllabus. The following unit-wise syllabus will assist you well. I hope this information is useful. Never forget to share it with your friends.

If you want to know more about the B.E Medical Electronics Engineering syllabus connected to an affiliated institution’s four-year undergraduate degree program. We provide you with a detailed Year-wise, semester-wise, and Subject-wise syllabus in the following link B.E Medical Electronics Engineering Syllabus Regulation 2021 Anna University.

Aim Of Objectives:

  • To study the characteristics of inverting, non-inverting, and instrumentation amplifiers.
  • To learn the linear and non-linear applications of operational amplifiers.
  • To know the combinational circuits.
  • To understand the function of sequential circuits.

List Of Experiments:

  1. Design of inverting and non-inverting amplifier.
  2. Design of Integrator and Differentiator.
  3. Design of Instrumentation amplifier.
  4. Design of Active low pass, High pass filter and Band pass filter.
  5. Design of Astable and Monostable multivibrator using 555 timer.
  6. Design of RC Phase shift and Wien bridge oscillators using op-amp.
  7. Design of Schmitt Trigger using op-amp.
  8. Design of DC power supply using LM317 and LM723.
  9. Design and implementation of code converters using logic gates
  10. Design and implementation of 4-bit binary Adder/ Subtractor and BCD adder using IC 7483.
  11. Design and implementation of multiplexer and Demultiplexer
  12. Design and implementation of encoder and decoder using logic gates.
  13. Design and implementation of shift registers.
  14. Design and implementation of Synchronous and asynchronous counters.
  15. Design and implementation of sequence detector.
  16. Simulation and analysis of circuits using software (any open access).

Related Posts On Semester – IV:

Also Check: